I received this case a few days ago, and finally decided to use it for my Custom Lady Eversharp razor. As you can see from the first two pics, it was gutted out and had to be re-lined. The outside also needed work as it had paint spots and was worn down in some areas.......... This was the easy part, cleaning and then painting the exterior with Black Acrylic paint and a couple of clear coats with Clear Enamel Spray Paint.......... For the interior, I cut strips of two-sided foam tape to line the interior sides with the flannel material, easier than glueing the flannel to heavy paper. Also three pieces of 1/4" foam that I saved from packing material, one for the top and two for the bottom with one that I made cutouts for the razor and injector dispenser. All were a bit oversize until the final fitting.......... This fifth pic with the blue flannel material attached to the foam tape and installed into the case. After fitting the foam liners, the blue flannel was attached to them.......... And in this pic, the liners are now installed.......... This pic showing the case just about done and the razor and blade dispenser in place.......... I had picked out an image to use for a decal, but it didn't work. When editing it, it just came out a bit blurry and fuzzy. So I picked out a simple image and used that for the outside top of the case, it seems to work..........