Jayaruh #195

There is a contractor in our neighborhood remodeling the home of a new resident. She brought him with her from Texas. I showed him my razors and brushes. Yesterday, he asked me if I would make him a brush with a hammer. I got to thinking, and this is what I came up with. He really liked it. He had told his wife about it and told her that he really hoped I could do something with the hammer motif. Well, I did, and he really liked it.

 

Great job did he adopt the 195? BTW it should go with a Fat Boy AKA 195.

 

That did not even dawn on me. If I were to do it over, I would have burned a 195 on the brush and called it 195 and made the hammer 196.

 

Very nicely done Jim

 

Change the 5 to a 6

 

Did ya tell him to go pound nails?

 

Thousands of comics out of work and you're tryin' to be funny.

 

I'm thinking of going into the biz.

 

I think melman needs to be made next... just sayin

Sent from my SM-G930P using Tapatalk

 

OK. Check it out. I made this handle without my lathe. I planned it out and shaped it with a drum sander, dremmel, and sand paper. I have put a clear coat on it, and it really pops. I will post pics of that later.

 

"Could not find attachment"

 

Try again, my friend. I was editing it.

 

^ Ah! That's "more better."

Nice work!

(Now, you need a matching razor handle with a brush on it. Just sayin.)

 

Nice! Like the color a lot!

Any details on the knot? Looks a little bigger and deeper?

Sent from my SM-G930P using Tapatalk

 

Looks great, but it's only set on 1. I think you have a winner!

What did you do to the other 195 brush?

 

The handle is 3.25 inches. The knot is Maggard 24mm synthetic. I will set it about 52mm. It is just stuck in right now.

 

Great job. The good looking brushes keep rolling of the assembly line.

 

I just did measurements. The knot is 27mm at the hole and 54mm loft.

 

I scuffed out the 5 and made it a 6. It is now 196.