I asked Bryan to make a Gen2 LVL1 with Vertigo handle, all in 7075 Aluminium. Unfortunately It was not available. I've used a brass LVL2, but It's a bit aggressive and waaaaay too heavy for my taste. OTOH, It's a true beauty. Congrats!!!
My Level 2 Gen 2 plate will mostly be parked with a Tibam Ti which gives good balance. Or with a weighted Fat Tech handle which works equally well.
Mail call today brought 12 empty, glass hot sauce bottles with reducers, so I can decant my AS from their plastic bottles. Can't wait for that improved Clubman scent.
brit #77 new rfb 2 piece with green case.. #175 canadian goodwill.. 1931 brit /french import new lc with #148 special new short bar thin cap..
Two brushes from @Enrico, a restored Warranteed #15 with a two band badger, and a Simpson BAC 3 needing a new knot. Also a Williams shave stick container which included some kind of brush that can make for a travel brush with a new knot................. EDIT: Just found out that the small brush is used to put shoe polish on.
Just in, Arctic Shave Butter by Strictly Man Supply Co. It is a non-foaming shave butter with peppermint oil. It was sent to me by the creators to try out and give my opinion. I normally don't care for the non-foaming products, but I will give it a try and an honest assessment.
These arrived yesterday. A Made Rite 325 on the left, and a Rubberset 303 on the right. I'm developing a real fetish for Lucite brushes. Any suggestions as to what I can use to polish/restore the rubber sections? I figure that whatever I use on the lucite...Flitz, etc...will too abrasive. Thanks in advance.
