Forgive me if this sounds silly but where on the razor head is its name? For example, I was examining my Edwin Jagger and I see the name circling the top of the handle but nothing on the head itself. So if the handle gets separated and mixed in with others how do you know what goes with what handle or am I just too new at this?
You're just too new at this. Tell you what...... Over the next 3 weekends, spend a minimum of 8 hours each day perusing the threads here at The Shave Den. Once your 48 hours is up, you'll no longer have any worries! Oh, and welcome to ya!
Not a silly question at all. You'd think manufacturers would want to put its logo all over the head, I'm sure it would cost a couple of pennies. My $185 Stainless Above The Tie has markings, most Single edge razors also have the makers name. If the handle and head get separated you wing it and call it a frankenrazor.
I usually start with, "Hey Baby, how you doin'?" and go from there. But, seriously folks, most 3 piece razor pieces all look very similar. So, best to keep sets together and maybe a little note to remind yourself what is what.
You gotta be careful around here bunchabull! You'll wind up with a custom title before you know it! Best wishes!
