I've been doing this 4 months. I am on my third pair of flush cutters. does anybody know of a brand that will cut the 1/16th Rods without breaking?
I bought quite a few over the years, I have only "Broken" one set on a SS 1/8" pin somebody put on an older Sheffielder,, dinged the blades I finally settled on the Cheapest out there because of the shallow angle they have, I do polish the bottoms so they don't scratch scales I have several pairs of much more expensive ones, but these are the ones I reach for almost everytime https://www.harborfreight.com/micro-flush-cutter-90708.html
These were the last ones I bought. Well made and sturdy. https://www.amazon.com/dp/B087P191LP/?tag=thshde-20