Need repair info for cracked handle

I have heard about filling the brass handle with epoxy, could someone explain how to do this without making a mess of this razor?

 

I would love to help buy i have not had much experience myself but i hope someone can help you out! good luck with it...let us know how it goes

 

Which razor is it?

 

Or if there is someone making replacement sleeves or stems for the early Gillettes. 1904's??

 

Its a New Tuckaway type short comb.

 

Wow that is a doozy, I would either epoxy a brass sleeve inside or solder using a no lead high silver content solder if I planned to re-plate. I have seen on another forum someone had newly machined ball end handles made. Your handle is very ornate the only replacement is probably from another razor.

 

That's what I was thinking.

 

My wife uses PMC to make silver jewelery, but it also comes in bronze. If someone wanted to start a restoration service, this, along with some needle files for restoring patterns, wouldn't be bad.
http://metalclay.com/rpm-cart/product.phtml?ProdID=MA1007B