Wostenholm & Sons EBRO

Discussion in 'Razor Restoration' started by gssixgun, May 10, 2015.

  1. gssixgun

    gssixgun At this point in time...

    Supporting Vendor
    Satin Glow Polish on the steel
    Camel Bone Scales @ .100"
    Green Malachite Wedge @.055" at the end
    Brass Pins
    Brass Bearing washers
    Triple Stacked Beehive Outer washers
    Chosera 1-5-10 Select Coticule finish

    [​IMG]

    [​IMG]

    [​IMG]


    Oh Holy hell it balances to the Tang like it should hehehe

    Honest I don't make this stuff up, go take out your Vintage SR's and check the balance, you will find very few that don't balance at the tang... Like most tools will balance where you hold them :)

    [​IMG]
     
  2. JoeB

    JoeB Well-Known Member

    Nice job Glen!!

    That bad boy must plow throw wiskers
     
    gssixgun likes this.
  3. HolyRollah

    HolyRollah BaconLord

    @gssixgun Glen, is that a custom scalloped spine treatment or was that an original wostenholm model design?
    Ideal for the 'fool's pass' grip! :D Love the satin finish on it! :happy088:
     
    gssixgun likes this.
  4. gssixgun

    gssixgun At this point in time...

    Supporting Vendor
    Kev I have seen it on a couple of different Sheffield makes sometimes only on the show side like this one and sometimes on both..

    @HolyRollah
     
    HolyRollah likes this.
  5. 45auto

    45auto Well-Known Member

    That is one classic shaver with a touch of elegance.
     
    gssixgun likes this.

Share This Page